Purpose
Used to pressure test tubing.
Application
Set in a PSN or profile nipple to check the integrity before or after the tubing is run.
Operation
Install the AW test plug in the desired nipple, this may be achieved by either wireline or by dropping the test plug and pumping it into place.
After pressure testing, lower the tool string with a JUS / RS pulling tool into wellbore and latch the second fishneck of the AW test plug, jar up to shear the pin and slide fishneck up to expose equalizing ports. After the tubing string has been equalized, pull the AW test plug from seal bore and remove tool string from the wellbore.
Precautions
The BT AW Test Plug holds pressure from above only, Ensure that the no-go on the AW test plug corresponds to the nipple to be utilized.
